curtis
New Forum Member
Posts: 1 
|
Post by curtis on Jul 14, 2018 17:46:53 GMT
I'm using PSE 13. Each time I switch my selection brush from Quick Selection to Selection Brush or vice versa, the cursor/brush size changes back to apparently whatever it was when I used that specific tool before. I'd like to have the size remain constant such that whatever size I make the brush will be the same if I say switch from Selection Brush to Quick Selection. Is there any way to accomplish this? It would save me a lot of time. Thanks, Curtis
|
|
|
|
Post by Sepiana on Jul 14, 2018 18:21:55 GMT
Hi Curtis, welcome to PSE&M! Glad to have you here.
I may be wrong (and someone, please, correct me if I am) but I don't see a way to accomplish what you want. Those tools are nested together but each one has its "independent/specific" settings. This means that, when you make a change in the cursor size, it will apply only to the tool which is activated at the moment.
|
|
|
|
Post by Major Major on Jul 14, 2018 19:58:18 GMT
Curtis -
Have you considered making the size of the brushes the same in the two modes?
|
|
|
|
Post by Sepiana on Jul 15, 2018 3:34:01 GMT
Craig, good thinking! I like your idea.
|
|
